PRODUCTS
Wear Parts Suppliers – CHOCKY BARS WITH METAL CERAMIC – Jinhua
Wear Parts Suppliers – CHOCKY BARS WITH METAL CERAMIC – Jinhua Detail:
This practice is suitable for Chocky bars only.
Note: For severe curves with a radius of less than 305mm, or inside curves, it is advisable to notch the mild steel
backing plate opposite the “V” to assist forming. (Figure A)
The Chocky bar may crack during bending. This is normal.
1. Clean the surface to which chocky bar will be welded.
2. Tack weld one end of the chocky bar(as per the welding procedure) in at least 3 places by 15mm minimum
length per weld(Figure 1)
3. Outside Curves: Hammer down unwelded end of bar with a soft face hammer to bend bar to match mating
radius. (Figure 2)
4. Inside curves: Starting the center strike bar with a soft face hammer to bend bar to match mating radius.
(Figure 3)
5. Cutting Details: High pressure abrasive water jet cutting is the preferred cutting method. Thermal cutting
using an oxyacetylene torch, arc-air or plasma is NOT recommended due to high localized heat input and high
risk of cracking, cutting by abrasive disc is an accepted practice.
Product detail pictures:
Related Product Guide:
It truly is our responsibility to fulfill your requirements and successfully provide you. Your fulfillment is our best reward. We're seeking forward in your check out for joint development for Wear Parts Suppliers – CHOCKY BARS WITH METAL CERAMIC – Jinhua , The product will supply to all over the world, such as: Netherlands, Paris, Mecca, The best and original quality for spare parts is a most important factor for transportation. We may stick on supplying original and good quality parts even a little profit earned. God will bless us to do kindness business forever.
By Karl from Guinea - 2017.10.25 15:53
The after-sale warranty service is timely and thoughtful, encounter problems can be resolved very quickly, we feel reliable and secure.
By Joanna from New Orleans - 2018.02.12 14:52
